11 12 Cylinder Head with Cover
WARNING: This page is about a different car, the 2008 MINI Cooper and 2007 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
CYLINDER HEAD WITH COVER TIGHTENING TORQUES
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Cylinder head bolts | N12 | 8x95 Replace screws | ||
| Jointing torque | 15 Nm | |||
| 1st angle of rotation | 90 ° | |||
| 2. Angle of rotation | 90 ° | |||
| 2AZ Cylinder head bolts | N12 | M10x145 | Replace screws | |
| Jointing torque | 30 Nm | |||
| 1st angle of rotation | 90 ° | |||
| 2. Angle of rotation | 90 ° | |||
| 3AZ Cylinder head bolts | N12 | M8x35 | Replace screws | 30 Nm |
| 4AZ Cylinder head cover to cylinder head | N12 | M6x30 | 10 Nm | |
| 5AZ Ground cable to cylinder head cover | N12 | M5 | 10 Nm | |
| 6AZ Bearing block of eccentric shaft to cylinder head | N12 | M6x40 M6x70 |
10 Nm | |
| 7AZ Inlet camshaft bearing cap to bearing block | N12 | M6x30.5 | 10 Nm | |
| 8AZ Exhaust camshaft bearing cap to cylinder head | N12 | M6x40 | 10 Nm | |
| 9AZ Lifting lug to cylinder head | N12 | M8x20 M8x25 |
20 Nm | |
| 10AZ VVT sensor to cylinder head | N12 | M6x40 | 10 Nm | |
| 11AZ Acoustic cover to cylinder head cover | N12 | M6x40 | 8.5 Nm |