51 42 000 Removing And Installing Left Or Right Rear Door Trim Panel

Special tools required: 

• 00 9 317 
• 00 9 322 

Press on point (A) and tilt out cover.

Release screw underneath.

Installation: 

Tightening torque 51 21 6AZ.  See BODY EQUIPMENT - TIGHTENING TORQUES -- ALPINA .

Fig 1: Removing Cover And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully lever caps (1) with special tool 00 9 322  out of door trim panel (2).

Fig 2: Identifying Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Installation: 

Tightening torque 51 42 1AZ.  See BODY EQUIPMENT - TIGHTENING TORQUES -- ALPINA .

Unclip clips (2) of door trim with special tool 00 9 317. 

Fig 3: Identifying Clips And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip door trim panel (1) at top from retainers (2).

Feed out door trim (1) from unlocking knob (3).

Fig 4: Removing Door Trim From Unlocking Knob

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook Bowden cable for release lever:

• Tighten release lever (1).
• Lever out lock (2).
• Detach Bowden cable (3) towards rear/top.

Installation: 

For fitting, press release lever (1) fully onto door trim panel.

Fig 5: Detaching Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Model with side airbag: 

Unlock plug connection (1) and disconnect from control unit.

Remove door trim panel (2).

Fig 6: Identifying Plug Connection And Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

All clips (1) are white.

If necessary, replace faulty clips (1).

Fig 7: Identifying Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

After assembling the door trim panel proceed as follows:

• Open door window.
• Lock with vehicle key.
• Check for ease-of-movement on retaining button linkage
• If necessary, align linkages