11 14 085 Removing And Installing Top Right Timing Case Cover (N62 / N62TU)

(cylinder bank 1 to 4) 

Necessary preliminary tasks: 

• Remove right cylinder head cover  . See 11 12 006 REMOVING AND INSTALLING/SEALING RIGHT CYLINDER HEAD COVER (N62/N62TU) .
• Remove vacuum pump  . See 66 VACUUM PUMP .
• Remove both solenoid valves on right side  . See 11 36 720 REMOVING AND INSTALLING/REPLACING BOTH RIGHT SOLENOID VALVES (N62/N62TU) .

Remove cable from holder.

Fig 1: Identifying Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2).

Remove timing case cover (3).

Fig 2: Identifying Timing Case Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Free sealing face (2) on timing case cover (3) of seal debris and clean.

Installation: 

Fig 3: Identifying Sealing Face On Timing Case Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Check adapter sleeves (1) for damage and correct installation position; replace if necessary.

Free sealing face (2) of seal debris and clean.

Fig 4: Identifying Sealing Face Of Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace gasket (1) and check for correct installation position.

Fig 5: Identifying Gasket

Courtesy of BMW OF NORTH AMERICA, INC.