11 51 000 Removing And Installing/Replacing Water Pump (N12)

WARNING: This page is about a different car, the 2008 MINI Cooper and 2007 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of scalding!
Only perform these tasks on an engine that has cooled down.

Recycling:

Catch and dispose of drained coolant.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Remove friction gear.

Release screws (1).

Installation:

Replace seal.

Clean sealing surfaces.

Fig 1: Identifying Water Pump Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Venting instructions must be observed without fail .