65 50 121 Removing And Installing Rear Cabin Monitor (Complete)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove fresh-air grille in rear cabin . See 64 22 191 REMOVING AND INSTALLING/REPLACING REAR CABIN FRESH-AIR GRILLE .
Remove trim from rear cabin monitor base at front . See 65 50 150 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR CABIN MONITOR BASE AT FRONT .

Release screws (1) and remove rear cabin monitor with holder (2).

Disconnect associated plug connections and feed out leads.

Tightening torque. See AUDIO, NAVIGATION AND ANTI-THEFT - TIGHTENING TORQUES - X5 .

Fig 1: Identifying Rear Cabin Monitor With Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure leads are correctly routed on both sides.

Fig 2: Identifying Monitor Leads

Courtesy of BMW OF NORTH AMERICA, INC.