51 42 000 Removing And Installing Left Or Right Rear Door Trim Panel

Special tools required: 

• 00 9 317 
• 00 9 323 

Necessary preliminary tasks: 

• Remove cover on door handle  . See 51 41 017 REMOVING AND INSTALLING/REPLACING COVER ON DOOR HANDLE AT FRONT (PASSENGER SIDE) LEFT OR RIGHT .

Release trim (1) with special tool 00 9 323  in direction of arrow from catches (2) and remove.

Fig 1: Identifying Special Tool (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2).

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip door trim panel (1) at clips (2) with special tool 00 9 317. 

Fig 3: Identifying Door Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip door trim panel (1) at top from retainers (2).

Disconnect all plug connections.

Fig 4: Identifying Door Trim Panel And Retainers

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook Bowden cable (1) from door lock (2).

Fig 5: Identifying Bowden Cable And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

If necessary, replace faulty clips (1).

Fit all clips with sealing ring.

Make sure clips are installed in correct position.

1. Grey clip
2. Light blue clip
   Fig 6: Identifying Light Blue Clips

   Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

After assembling the door trim panel proceed as follows:

• Open door window.
• Lock with vehicle key.
• Check for ease-of-movement on retaining button linkage
• If necessary, align linkages