34 32 951 Replacing Rear Left Or Right Brake Hose (Between Rear Axle Carrier And Body)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 34 3 170. See 34 3 170 SET OF SOCKET WRENCHES
NOTE:
Read and comply with General Information. See 34 00 ... General Information
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
NOTE:
The pedal support may only be released when the brake lines are reconnected.
This prevents brake fluid from emerging from the expansion tank and air from entering the system when the brake lines are opened.
IMPORTANT:
Grip brake hose at square drive to prevent connecting piece from turning in retaining bracket. Never twist brake hose (2) when installing it and avoid all contact with parts attached rigidly to the body.
Disconnect brake hose (2) from brake line (1).
Detach brake hose from brake line (3) and remove brake hose (2).
Installation:
Tightening torque 34 32 1AZ. See 32 BRAKE LINES
Installation:
Use torque wrench (Hazet 6282-1CT with reversible ratchet head).
Tighten brake line using torque wrench (1) and special tool 34 3 170. See 34 3 170 SET OF SOCKET WRENCHES