24 31 575 Replacing oil pump O-rings (GA6HP26/19Z)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

24 1 180
24 1 184

IMPORTANT: After completion of work, check transmission oil level (GA6HP19Z) or transmission oil level (GA6HP26Z) .
Use only approved transmission oil. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.

Necessary preliminary tasks:

Remove automatic transmission. See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP26Z) N62TU or 24 00 030 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP19Z) N52K .
Secure transmission with transmission holding bridge on assembly stand.
Remove torque converter. See TORQUE CONVERTER
Remove mechatronics .

Remove adapter (1). Installation: Note installation position.

Fig 1: Remove Adapter (1)

G00497074

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws. Tightening torque 24 31 3AZ.

Fig 2: Remove Screws As Shown

G00497075

Courtesy of BMW OF NORTH AMERICA, INC.

Slide special tool 24 1 184 completely into puller 24 1 180.

Fig 3: Slide Special Tool 24 1 184 Completely Into Puller 24 1 180

G00497238

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 24 1 180 and secure with screw (1). Insert screw (2) and release oil supply unit from transmission housing.

Fig 4: Attach Special Tool 24 1 180 And Secure With Screw

G00497239

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws. Tightening torque 24 31 1AZ.

Fig 5: Release Screws As Shown

G00497240

Courtesy of BMW OF NORTH AMERICA, INC.

Detach cover (1) from pump body (2). Replace O-rings (3 + 4). Installation: Pay attention to installation position of gears during disassembly.

Fig 6: Detach Cover (1) From Pump Body

G00497241

Courtesy of BMW OF NORTH AMERICA, INC.