11 31 052 Replacing Both Timing Chains (N62/N62TU)

WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 2 001
11 2 002
11 2 003
11 2 007

Necessary preliminary tasks:

Remove lower timing case cover . See 11 14 110 REMOVING AND INSTALLING BOTTOM TIMING CASE COVER (N62/N62TU) .

Remove timing chain (1).

Remove timing chain (5).

Release screws (7).

Remove guide rails (3 and 6).

Remove tensioning rails (2 and 4).

Installation:

Maintain tension of timing chains when installing timing case cover.

Observe sparking protection on timing case cover.

Make sure timing chain (1) is correctly installed when placing it in guide rail (3).

Fig 1: Identifying Timing Chains, Screws And Guide Rails

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tools 11 2 001 and 11 2 002 to crankshaft.

Insert special tool 11 2 007 and remove sprocket wheel with special tool 11 2 003 .

Installation:

Check sprocket wheels for wear, replace if necessary.

Heat sprocket wheel to 60°C.

WARNING: Burning hazard! Wear gloves.

Fig 2: Identifying Special Tool (11 2 007), (11 2 001), (11 2 003)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.