54 34 127 Removing and installing/replacing cowl panel trim (convertible top fastener)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Open convertible top partially until work area is accessible

Carefully raise seal (1) and expose screw (2).

Release screws (2).

Fig 1: Identifying Seal And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trip towards front (1) and remove towards bottom (2).

Installation:

If necessary, replace faulty clips.

Fig 2: Uncliping Trip Front

Courtesy of BMW OF NORTH AMERICA, INC.