54 34 034 Removing and installing/replacing complete hydraulic system for convertible top
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove hydraulic cylinder for convertible top
- Remove hydraulic cylinder for convertible top compartment lid
- Remove hydraulic cylinder for clamping bar
NOTE:
Hydraulic circuit remains closed during this operation.
Release Torx screws.
Installation:
Replace Torx screws and insert with Loctite.
If necessary, disconnect cable straps from hydraulic lines.
Remove hydraulic unit (1) with hydraulic system.