54 34 018 Removing and installing/replacing convertible top compartment

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Open convertible top compartment lid until all hydraulic cylinders are completely extended.

Support convertible top compartment lid in service position. . See 51 00 ... Service position of convertible top compartment lid .

Fig 1: Identifying Convertible Top Compartment Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws.

Remove complete hydraulic unit (1) until screws of convertible soft top compartment are exposed.

Fig 2: Removing Hydraulic Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws all round.

Tightening torque 54 34 18AZ . See SLIDE/TILT SUNROOF AND CONVERTIBLE TOP - TIGHTENING TORQUES .

Raise convertible top compartment slightly and move a little to left.

Unfasten plug connection and disconnect.

Lift out convertible top compartment toward top and front.

Fig 3: Locating Convertible Compartment Screws

Courtesy of BMW OF NORTH AMERICA, INC.