51 71 Gaskets and loose body components
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
SEALS AND LOOSE BODY PARTS - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Front spoiler to bumper | E36 / M3 | 3 Nm | ||
| 2AZ | Rear spoiler | E34 / Touring, E36 / Z3 Coupe / M Coupe | M6 | 6 Nm | |
| E36 / M3 | M6 | 7 Nm | |||
| E53 | 3 Nm | ||||
| E83 | M6 | 10 Nm | |||
| E61 | 8 Nm | ||||
| 3AZ | Reinforcement plate to front axle support/engine carrier | E46 / without AWD, E85, E86 | Replace screws | ||
| Jointing torque | 59 Nm | ||||
| Torque angle | 90 ° | ||||
| 4AZ | Tension strut in engine compartment | E85, E86 | Nut | 41 Nm | |
| Replace screw | 56 Nm | ||||
| Torque angle | 105 ±15 ° | ||||
| E83 | M8 | 19 Nm | |||
| 5AZ | Reinforcing plate / tension strut to rear axle | E46 / Convertible, E85, E86 | M10 | Replace screws | |
| Jointing torque | 59 Nm | ||||
| Torque angle | 90 ° | ||||
| 6AZ | Stiffening plate to body | E85, E86 | M8 | 21 Nm | |
| 7AZ | Tension strut to rear axle | E46 / Convertible | M8 | 24 Nm | |
| E85, E86 | Replace nut | 24 Nm | |||
| 8AZ | Cross-member, A-pillar, to mounting | E52 | M8 | 19 Nm | |
| 9AZ | Cross-member, A-pillar, middle | E52 | M8 | 10 Nm | |
| 10AZ | Strut to cardan tunnel | E52 | M8 | 19 Nm | |
| 11AZ | Cross-member, A-pillar, bottom, to mounting | E52 | M6 | 11 Nm | |
| 12AZ | Support tube to support, steering column upper section | E65, E66, E67 | M8 | 21 Nm | |
| 13AZ | Support tube to body | E85 / E86 | M8 | 20 Nm | |
| 14AZ | Heater to support tube | E85, E86 | 4 Nm | ||
| 15AZ | Support tube to body | E60, E61, E63, E64, E83 | M8 | 21 Nm | |
| 16AZ | Take-up, cover, sill to body | E83 | M8 | 5 Nm | |
| 17AZ | Cover, partition, to body, front | E61 | 2.5 Nm | ||
| 18AZ | Retaining strip, sill trim, to side panel | E61 | 5 Nm | ||
| 19AZ | Multifunction pan to body | E60 / M5 | 3 Nm | ||
| E86 | 12 Nm | ||||
| 20AZ | Underride protection to retaining bar | E60, E61 | M8 | Replace screws | 8 Nm |
| 21AZ | Retaining bar for underride protection to frame side member | E60, E61 | M8 | Replace screws | 8 Nm |
| 22AZ | Protective mat/protective cover to body | E60 / Security | M6 | Screw | 10 Nm |