65 90 550 Replacing CD/DVD drive for navigation computer

Special tools required: 

• 00 9 318 

Comply with notes and instructions on handling navigation computers, see 65 90 ... Notes on handling navigation computers .

Replace the destroyed seal on all devices with the new seal supplied.

Necessary preliminary tasks: 

• Remove navigation computer, see 65 90 511 Removing and installing (replacing) navigation computer with CD drive .

MK II version: 

Cut through seal (1).

Release screws (2) on both sides and carefully fold down front panel (3).

Installation: 

Replace the destroyed seal with the new seal supplied.

Fig 1: Screws On Both Front Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Lever cover (1) with special tool 00 9 318  upwards out of side catches.

Fig 2: Special Tool (00 9 318)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and carefully lift out CD drive (2).

Fig 3: Screws And CD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

MK III and MK IV versions: 

Cut through seal (1).

Carefully lever off cover (2) with special tool 00 9 318. 

Installation: 

Replace the destroyed seal with the new seal supplied.

Fig 4: Special Tool (00 9 318)

Courtesy of BMW OF NORTH AMERICA, INC.

MK III version: 

Release screws (1) and carefully lift out drive (2).

Fig 5: Screws And Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and remove drive (2).

Fig 6: Plug Connections And Drive

Courtesy of BMW OF NORTH AMERICA, INC.

MK IV version: 

Release screws (1).

Carefully lift out DVD drive (2).

Fig 7: Screws And DVD Drive

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connections (1) and remove DVD drive (2).

Fig 8: Plug Connections And DVD Drive

Courtesy of BMW OF NORTH AMERICA, INC.