65 50 011 Removing and installing (replacing) video module for on-board monitor

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with 61 35 ... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .

Necessary preliminary tasks:

Disconnect battery negative lead, seeTHE BATTERY .
Remove flap in luggage compartment panel on left, see 51 47 172 REMOVING AND INSTALLING/REPLACING FLAP IN LUGGAGE COMPARTMENT TRIM, LEFT OR RIGHT .

Unlock plug connections (1) and disconnect.

Installation:

Do not mix up antenna connectors (2).

Mark antenna plugs (2) and disconnect.

Release screws (3).

Release nut on stud (4).

Guide video module for on-board monitor (5) with holder over stud (4) and feed out in direction of arrow.

Fig 1: Antenna Connectors

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Unclip wiring harness (2) at point (3) and pull video module for on-board monitor (4) with holder (5) out of side recess slightly.

Feed video module for on-board monitor (4) in direction of arrow out of holder (5) and remove.

Fig 2: Wiring Harness And On-Board Monitor With Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out programming/coding using appropriate BMW service tool.