67 62 020 Removing and installing/replacing flat motor for rear left or right power window unit
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Detach sound insulation on rear door in working area, see 51 48 070 REMOVING AND INSTALLING/REPLACING SOUND INSULATION ON LEFT OR RIGHT REAR DOOR .
NOTE:
For clearer illustration, shown with sound insulation removed.
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach flat motor for power window unit (3) in direction of arrow from power window unit (4) and remove.
Installation:
Fit flat motor for power window unit (3) exactly on teeth of power window unit.
Replacement:
A normalization must be carried out in order to activate anti - trapping protection.
Operating sequence for normalization:
- Open corresponding window completely.
- Operate corresponding power window switch in "Close" position (second switch stage).
- Once the upper end position has been reached, hold power window switch down for approx. 1 second more.
Normalization is thus completed.
NOTE:
Carry out function check (one-touch function, anti-trapping protection and, if necessary, comfort function).