67 61 517 Replacing drive with gear (rear) for actuating slide/tilt sunroof
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove rear grab handles, see 51 16 450 REMOVING AND INSTALLING/REPLACING REAR LEFT/RIGHT GRAB HANDLE .
- Remove trim for rear left and right roof pillar (C-pillar), see 51 43 251 REMOVING AND INSTALLING/REPLACING TRIM PANEL FOR REAR LEFT OR RIGHT ROOF PILLAR (C - PILLAR) .
- Remove trim for rear left and right roof pillar (D-pillar), see 51 43 252 REPLACING TRIM PANEL FOR REAR LEFT OR RIGHT ROOF PILLAR (D-PILLAR) .
- Remove left and right interior lights, see 63 31 015 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT INTERIOR LIGHT (SIDE ROOFLINER) .
- Detach mucket in area of roofliner
IMPORTANT:
Do not under any circumstance kink roofliner (1).
Unclip roofliner (1) at retaining point (2) towards bottom and lower.
NOTE:
Secure drive with gear for actuating slide/tilt sunroof (4) against falling out.
Release screws (3), tightening torque: 1AZ, see 54 13 ELECTRIC SUN ROOF COMPONENTS .
Lower drive with gear for actuating slide/tilt sunroof (4).
NOTE:
Screws (3) are microencapsulated.
Unlock plug connection (5), disconnect and remove drive with gear for actuating slide/tilt sunroof (4).
Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).
Installation:
- Initialize Panorama Glass Roof, see 54 0 ... NOTES ON PANORAMA GLASS ROOF (INITIALIZATION/NORMALIZATION/LEARNING OF CHARACTERISTIC CURVE) .