34 41 220 Removing and installing/replacing all handbrake shoes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove rear brake disk

After completing work:

Adjusting handbrake, see 34 10 014 Adjusting handbrake .

Release handbrake lever.

Lock adjuster unit (ASZE).

Using special tool 32 1 030 , press stop (1) of adjusting spring back to such an extent that retaining hook (2) engages in stop (1).

Fig 1: Special Tool (32 1 030) With Retaining Hook

G04726693

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Check and if necessary replace return spring (1).

Pay attention to installation position of adjustment screw (2).

Apply a thin coat of grease to bush and screw threads.

Fig 2: Return Spring And Screw

G04726694

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect return spring (1) with brake spring pliers.

Installation:

Check and if necessary replace return spring (1).

Fig 3: Return Spring

G04726695

Courtesy of BMW OF NORTH AMERICA, INC.

Turn clamping pins (1) with special tool 34 4 000 through 90° and disconnect.

Remove brake shoes (2).

Fig 4: Clamping Pins, Brake Shoes With Special Tool (34 4 000)

G04726696

Courtesy of BMW OF NORTH AMERICA, INC.