34 11 000 Removing and installing/replacing brake linings of both front disc brakes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove wheels, see 36 10 300 REMOVING OR INSTALLING FRONT OR REAR WHEEL .

NOTE: After completing work:

Fully depress brake pedal several times so that brake linings contact brake discs.
When installing new brake linings at front and rear axles, brake fluid level must be brought up to "MAX" marking.
Read and comply with notes on braking in new brake discs / brake pads, see 34 00 ... General information on braking in new brake discs / brake pads .

Lift out retaining spring (1).

Left:

Disconnect plug connection for brake lining wear sensor.

If necessary, replace brake lining wear sensor, see 34 35 001 Replacing a brake lining sensor .

Fig 1: Retaining Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Remove plastic plugs (2).

Fig 2: Plastic Plugs

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten guide screws (1) and lift out brake caliper towards rear of vehicle. Do not allow brake caliper to hang from brake hose, risk of damage to brake hose.

Installation:

Only clean guide screws; do not grease.

Check threads.

Replace all guide screws which are not in perfect condition.

Installation:

Tightening torque: 34 11 3AZ, see 34 11 FRONT BRAKE .

Fig 3: Brake Caliper And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Turn piston fully back with special tool 34 1 050.

IMPORTANT: When turning back the piston, watch the brake-fluid level in the expansion tank, as overflowing brake fluid will destroy the paintwork.

Fig 4: Retracting Piston With Special Tool (34 1 050)

Courtesy of BMW OF NORTH AMERICA, INC.

Remove outer brake lining.

Inner brake lining is located with its spring in the piston.

IMPORTANT: Mark any worn brake linings.

In the event of one-sided brake lining wear, do not change brake linings round.

New brake linings may only be installed if the brake disc thickness is greater than or equal to the minimum brake disc thickness (MIN TH), see 34 11 FRONT BRAKE E83 .

Observe minimum thickness of brake linings, see 34 11 FRONT BRAKE E83 , Clean brake linings.

Do not grease backs of brake linings sleeve.

Fig 5: Removing Outer Brake Lining

Courtesy of BMW OF NORTH AMERICA, INC.

Check dust sleeve (1) for damage and replace if necessary.

Clean contact face (2) of brake piston and apply a thin coating of anti-squeak compound.

IMPORTANT: Dust sleeve must not come into contact with anti-squeak compound as this may cause the dust sleeve to swell.

Fig 6: Contact Face And Dust Sleeve

Courtesy of BMW OF NORTH AMERICA, INC.

Clean contact faces (1...2) of brake lining hammer heads/brake caliper housing and coat with anti-squeak compound.

Fig 7: Contact Face Of Brake Piston

Courtesy of BMW OF NORTH AMERICA, INC.

Clean contact face (3) of brake caliper and apply a thin coating of anti-squeak compound.

Fig 8: Brake Caliper And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Clean contact face of brake caliper mounting bracket and apply a thin coating of anti-squeak compound.

Fig 9: Locating Brake Caliper Mounting Bracket

Courtesy of BMW OF NORTH AMERICA, INC.