32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt".
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
Tightening torque: 32 41 14AZ, see 32 41 PUMP AND OIL SUPPLY .