72 12 015 Removing and installing/replacing airbag module on left or right rear door
WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Read and comply with safety regulations
for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
Necessary preliminary tasks:
- Disconnect battery negative lead
Follow instructions for disconnecting and connecting battery .
- Remove rear door trim
Release screw (1).
Release nuts (2) and remove holder (3).
Installation:
For tightening torque refer to 72 12 01AZ in 72 12 AIRBAG MODULES .
Coat nut and thread with paint (any color and type can be chosen).
Fold back tabs (1) of plastic housing and remove airbag module (2) from airbag mounting.
Installation:
There must be no foreign objects (e.g. screws, nuts etc.) in the airbag mounting in the door trim panel.
IMPORTANT:
There must be no foreign bodies (e.g. screws, nuts, etc.) in the airbag mounting (1).
Installation:
Slots (2) of holder (1) must be positioned over threaded pins (3).
Point angled part of holder (1) to door trim panel.