72 11 102 Removing and installing/replacing all rear seat belts

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt tensioners.

Incorrect handling may trigger the pyrotechnical seatbelt tensioner or side airbag and thereby cause injuries.

Switch off ignition!

Removing left and right seat belts:

Release screws (1) on left and right.

Unscrew nut (3).

Installation:

Guide lug of belt retractor must be seated in opening in body.

For tightening torque refer to 72 11 20AZ in 72 11 SEAT BELTS .

Key:

Retaining screw
Belt retractor
Securing nut
Belt retractor

Fig 1: Belt Retractor, Securing Nut And Retaining Screw
Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on left and right.

For tightening torque refer to 72 11 23AZ in 72 11 SEAT BELTS .

Disconnect plug connection (2).

Remove upper strap (3) on left and right.

Fig 2: Upper Strap, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Removing middle seat belt (except E67):

Release screws (1).

For tightening torque refer to 72 11 21AZ in 72 11 SEAT BELTS .

Remove lower straps (2) and center upper strap (3).

Fig 3: Upper And Lower Strap And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Ensure correct installation sequence and installation position:

Fittings of center lower strap/center upper strap must rest on stop (1).
Secure lower strap on left and right through guides (2).

Fig 4: Center Lower Strap/Center Upper Strap And Guides
Courtesy of BMW OF NORTH AMERICA, INC.