51 47 000 Removing and Installing/Replacing Entrance Cover Strip, Front (Inside) Left or Right
WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
Detach entrance cover strip (1) from front and rear trims.
Unclip entrance cover strip (1) in direction of arrow from floor plate.
If necessary, lever clips (2) with end cutting pliers (head of pliers surface-ground) out of floor pan.
Installation:
Clip mounts of entrance cover strip (2) must not be damaged.
Push clips (1) onto entrance cover strip (2).
If necessary, replace faulty clips (1).