51 22 126 Removing and Installing/Replacing Carrier For Outside Door Handle On Left or Right Rear Door

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear outside handle See 51 22 170 REMOVING AND INSTALLING/REPLACING OUTSIDE HANDLE ON LEFT OR RIGHT BACK DOOR

Release screw (1).

Feed carrier out of guide (2) and lower at front downwards.

Fig 1: Identifying Feed Out Carrier Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure guides are correctly fed in.

Fig 2: Locating Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Remove carrier through handle opening.

Fig 3: Removing Carrier Handle Opening

Courtesy of BMW OF NORTH AMERICA, INC.

Protect door outer skin (e.g. cleaning cloth).

Feed fiber optics cable out of clip (1).

NOTE: No fibre optics cable is fitted from build date 09/2004.

If necessary, withdraw Bowden cable sleeve (2) with clip (3) from retaining fixture.

Feed Bowden cable out of actuating lever (4).

Remove carrier.

Fig 4: Identifying Bowden Cable Actuating Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clip is on fitted on Bowden cables with blue sealing caps (1).

Position of clip on Bowden cable:

2 = small hole side

Fig 5: Identifying Bowden Cables With Blue Sealing Caps

Courtesy of BMW OF NORTH AMERICA, INC.