51 21 225 Removing and Installing or Replacing Inside Door Opener In Left or Right Front Door

WARNING: This page is about a different car, the 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 321
00 9 323

Press on point (A) and tilt cover.

Remove cover and release screw underneath.

Tightening torque 51 21 6AZ . See 51 21 FRONT DOOR LOCKS

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Raise edge of door opener with cleaning wedge 00 9 323 slightly to be able then to lever out door opener with fishbone 00 9 321 .

Carefully feed door opener forwards and downwards out of door trim.

IMPORTANT: If the door opener is pulled out too vigorously, there is a risk of damage to the door opener and the Bowden cable.

Fig 2: Identifying Special Tool (00 9 321) & (00 9 323)

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock holder for Bowden cable (1) and remove door opener (2).

Fig 3: Identifying Door Opener (1 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Place door opener (1) at front on holder for Bowden cable (2) and clip into place.

Lever of door opener must be held "closed" in the process.

Fig 4: Identifying Door Opener (2 Of 2)

Courtesy of BMW OF NORTH AMERICA, INC.