24 31 010 Replacing Torque Converter Shaft Seal (GA6HP26Z/6HP32Z)

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 1 450
24 0 200
24 2 351
24 2 352
24 2 353
24 2 360

Necessary preliminary tasks:

Remove automatic transmission. See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (6HP26Z/6HP32Z)

IMPORTANT:

After completion of work, check transmission oil level. See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6HP26Z/6HP32Z)

Use only approved transmission oil. See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .

Failure to comply with this instruction will result in serious damage to the transmission.

Secure transmission with special tool 24 0 200 to assembly stand 00 1 450. See 24 0 200 SUPPORT and 00 1 450 ASSEMBLY STAND

Remove torque converter. See 24 40 010 REMOVING AND INSTALLING/REPLACING TORQUE CONVERTER (GA6HP26Z/6HP32Z)

Fig 1: Identifying Special Tool (20 0 200)

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 24 2 353 to drive shaft (1).

Fig 2: Identifying Special Tool (24 2 353)

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 2 351 until it is firmly connected with shaft seal.

Screw in special tool 24 2 352 to remove shaft seal.

Fig 3: Identifying Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal.

Drive in shaft seal (1) with special tool 24 2 360 as far as it will go.

Fig 4: Identifying Special Tool (24 2 360)

Courtesy of BMW OF NORTH AMERICA, INC.