18 12 561 Replacing rear muffler (N73)

WARNING: This page is about a different car, the 2008 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 2 210

WARNING: Scalding hazard!

Only perform these tasks after exhaust system has cooled down.

Unfasten screws.

Remove reinforcement plate.

Fig 1: Reinforcement Plate And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Cutting line (7) between center muffler (2) and rear muffler (1).

Determine pipe length on new rear muffler.

Carry over dimensions to faulty rear muffler (1) and mark cutting line.

Fig 2: Muffler Components And Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Cut tail pipe with special tool 00 2 210 at marked point.

Installation:

Deburr cutting line.

Fig 3: Special Tool (00 2 210)

Courtesy of BMW OF NORTH AMERICA, INC.

Connect new rear muffler with clamping sleeve.

Installation:

Align clamping sleeve so that:

Nuts point downwards.
Cutting line is in middle of clamping sleeve.
There is sufficient spacing to adjoining components.

Fig 4: Muffler Components And Assembly
Courtesy of BMW OF NORTH AMERICA, INC.

Add final details to vehicle.

Check exhaust system for leaks.