11 14 080 Removing and Installing Top Left Timing Case Cover (N73)

WARNING: This page is about a different car, the 2008 BMW 760Li and 2007 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove intake air manifold. See 11 61 050 Removing and Installing Intake Air Manifold (N73)
Remove left cylinder head cover. See 11 12 005 Removing and Installing/Sealing Left Cylinder Head Cover (N73)
Remove fan. See 11 52 020 Removing and Installing Or Replacing Fan Clutch (N73)

Disconnect plug connection on solenoid valves.

Release screws and remove holder (1).

Remove solenoid valves (2) towards front.

Release screws along line (3).

Remove timing case cover (4) towards front.

Fig 1: Identifying Solenoid Valves And Timing Case Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Check adapter sleeves (1) for damage and correct installation position; replace if necessary.

Clean sealing faces (2).

Installation:

Replace gasket and ensure correct installation position.

Fig 2: Identifying Adapter Sleeves And Sealing Faces

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.