51 71 Seals and Loose Body Parts
WARNING: This page is about a different car, the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, and 2007 BMW 750Li. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATION - SEALS AND LOOSE BODY PARTS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Front spoiler to bumper | E36/M3 | - | - | 3 Nm |
| 2AZ Rear spoiler | E34/Touring, E36/Z3 Coupe/M Coupe | M6 | - | 6 Nm |
| - | E36/M3 | M6 | - | 7 Nm |
| - | E53 | - | - | 3 Nm |
| - | E83 | M6 | - | 10 Nm |
| - | E61 | - | - | 8 Nm |
| 3AZ Reinforcement plate to front axle support/engine carrier | E46 / without AWD, E85, E86 | - | Replace screws | - |
| - | - | - | Jointing torque | 59 Nm |
| - | - | - | Torque angle | 90° |
| 4AZ Tension strut in engine compartment | E85, E86 | - | Nut | 41 Nm |
| - | - | - | Replace screw | 56 Nm |
| - | - | - | Torque angle | 105 ±15° |
| - | E83 | M8 | - | 19 Nm |
| 5AZ Reinforcing plate / tension strut to rear axle | E46 / Convertible, E85, E86 | M10 | Replace screws | - |
| - | - | - | Jointing torque | 59 Nm |
| - | - | - | Torque angle | 90° |
| 6AZ Stiffening plate to body | E85, E86 | M8 | - | 21 Nm |
| 7AZ Tension strut to rear axle | E46 / Convertible | M8 | - | 24 Nm |
| - | E85, E86 | - | Replace nut | 24 Nm |
| 8AZ Cross-member, A-pillar, to mounting | E52 | M8 | - | 19 Nm |
| 9AZ Cross-member, A-pillar, middle | E52 | M8 | - | 10 Nm |
| 10AZ Strut to cardan tunnel | E52 | M8 | - | 19 Nm |
| 11AZ Cross-member, A-pillar, bottom, to mounting | E52 | M6 | - | 11 Nm |
| 12AZ Support tube to support, steering column upper section | E65, E66, E67 | M8 | - | 21 Nm |
| 13AZ Support tube to body | E85/E86 | M8 | - | 20 Nm |
| 14AZ Heater to support tube | E85, E86 | - | - | 4 Nm |
| 15AZ Support tube to body | E60, E61, E63, E64, E83 | M8 | - | 21 Nm |
| 16AZ Take-up, cover, sill to body | E83 | M8 | - | 5 Nm |
| 17AZ Cover, partition, to body, front | E61 | - | - | 2.5 Nm |
| 18AZ Retaining strip, sill trim, to side panel | E61 | - | - | 5 Nm |
| 19AZ Multifunction pan to body | E60 / M5 | - | - | 3 Nm |
| - | E86 | - | - | 12 Nm |
| 20AZ Underride protection to retaining bar | E60, E61 | M8 | Replace screws | 8 Nm |
| - | E60, E61 | M8 | Replace screws | 8 Nm |
| 21AZ Retaining bar for underride protection to frame side member | - | - | - | - |
| 22AZ Protective mat/protective cover to body | E60 / Security | M6 | Screw | 10 Nm |