67 31 610 Removing and Installing/Replacing Drive For Seat Tilt Adjustment (Comfort Seats In Rear Compartment)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.
Remove rear seat padding completely. See 52 25 002 REMOVING AND INSTALLING PADDING FOR LEFT OR RIGHT REAR SEAT .
Disconnect plug connection (1). If necessary, cut through cable tie.
Release screws (2).
Detach drive for seat tilt adjustment (3) from drive shaft (4) and feed out in direction of arrow.
Installation:
Make sure drive shaft (4) is correctly seated.
Replacement:
Initialize drive unit for seat tilt adjustment. See 67 31 ... NOTES ON INITIALIZING ELECTRIC SEAT SERVODRIVES