67 31 600 Removing and Installing/Replacing Drive For Seat Longitudinal/Tilt Adjustment (Comfort Seats In Rear Compartment)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove rear seat padding completely. See 52 25 002 REMOVING AND INSTALLING PADDING FOR LEFT OR RIGHT REAR SEAT .

Detach retainers (1) at both rubber straps and pull gap cover (2) forwards slightly.

Fig 1: Detaching Retainers At Both Rubber Straps & Pulling Gap Cover Slightly Forward

Courtesy of BMW OF NORTH AMERICA, INC.

Cut through cable ties (1) and pull gap cover (2) downwards.

Installation:

Make sure cable ties are correctly positioned.

Release both clips (3) and remove trim (4) towards top.

Fig 2: Releasing Both Clips & Removing Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Release screws (2).

Detach drive for seat longitudinal/tilt adjustment (2) from drive shafts (4) and feed out in direction of arrow.

Fig 3: Detaching Drive For Seat Longitudinal/Tilt Adjustment From Drive Shafts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure drive shafts (4) are correctly seated.

Replacement:

Initialize drive for seat longitudinal/tilt adjustment. See 67 31 ... NOTES ON INITIALIZING ELECTRIC SEAT SERVODRIVES