51 43 251 Removing And Installing / Replacing Trim For Rear Left Or Right Roof Pillar (Rear)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Version with head airbag:

FOLLOW safety instructions for working on cars with airbag systems.

IMPORTANT:

Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Version with head airbag in rear compartment:

If necessary, lever out airbag emblem (1) and release screw underneath.

Tightening torque: 51 43 1AZ . See SIDE TRIM PANEL WITH ARMRESTS for specs.

Release clips (2) and catches (4) from trim (3).

Pull out trim (3) towards inside at top.

Fig 1: Pulling Out Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace defective grommets (1).

Fig 2: Identifying Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retainer (1) on trim (2) must not be damaged or missing.

Fig 3: Identifying Retainer On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, replace faulty clips (1) of panel (3).

Catches (2) on trim (3) must not be damaged.

Fig 4: Identifying Catches On Trim

Courtesy of BMW OF NORTH AMERICA, INC.