51 16 060 Removing And Installing/Replacing Interior Rearview Mirror (With Full Foot)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2008 BMW 760Li, 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 760Li, and 2007 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Work may only be carried out at a room/object temperature of 18 ... 28°C.

If this cannot be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror foot and rearview mirror (e.g. car left to stand indoors or in the shade for at least 30 minutes).

IMPORTANT:

To avoid breaking windscreen:

Snap out (press) rearview mirror only in direction of travel towards windscreen.

Do not under any circumstances twist the mirror foot when removing.

Twisting the mirror off the mirror mount will damage the rear catch.

If the rear catch is damaged, the mirror will be loose when installed and must be replaced.

IMPORTANT:

Risk of damage!

Do not pull off rearview mirror (1) from windscreen against direction of travel and or snap out by turning.

Snap out interior mirror (1) from mirror mount (2) towards front with increasing pressure (not abruptly) and remove.

Fig 1: Snaping Out Interior Mirror From Mirror Mount

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Twist mirror foot by approx. 45 ° and fit to mirror mount.
Turn mirror foot until it engages on mirror base.

Fig 2: Twisting Mirror Foot

Courtesy of BMW OF NORTH AMERICA, INC.