24 31 010 Replacing Torque Converter Shaft Seal (GA6HP26Z/6HP32Z)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 1 450
24 0 200
24 2 351
24 2 352
24 2 353
24 2 360

Necessary preliminary tasks:

Remove automatic transmission . See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (6HP26Z/6HP32Z)

IMPORTANT:

After completion of work, check transmission oil level . See 00 11 500 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6HP26Z/6HP32Z) .

Use only approved transmission oil . See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .

Failure to comply with this instruction will result in serious damage to the transmission.

Secure transmission with special tool 24 0 200 to assembly stand 00 1 450 . See 24 0 200 SUPPORT

Remove torque converter . See 24 40 010 REMOVING AND INSTALLING/REPLACING TORQUE CONVERTER (GA6HP26Z/6HP32Z)

Fig 1: Identifying Special Tool (24 2 200)

G04726128

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 24 2 353 to drive shaft (1).

Fig 2: Identifying Special Tool (24 2 353)

G04726129

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 2 351 until it is firmly connected with shaft seal.

Screw in special tool 24 2 352 to remove shaft seal.

Fig 3: Identifying Special Tool (24 2 351) & (24 2 352)

G04726130

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip on shaft seal.

Drive in shaft seal (1) with special tool 24 2 360 as far as it will go.

Fig 4: Identifying Special Tool (24 2 400) & (24 2 360)

G04726131

Courtesy of BMW OF NORTH AMERICA, INC.