11 13 Oil Pan
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW 335xi, 2010 BMW 335i, 2009 BMW 335xi, 2009 BMW 335i, and 2008 BMW 335xi. However, it is still accessible from the selected car via links, so may be relevant.
OIL SUMP TIGHTENING SPECIFICATION
| - | Type | Thread | Tightening Specification | Measure | |
|---|---|---|---|---|---|
| 1AZ | Oil drain plug | N54 | M12 x 1.5 | - | 25 Nm |
| 2AZ | Oil pan on engine block Aluminum oil sump Aluminum screws/bolts are marked with blue paint. |
N54 | M8 x 26 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
- |
| - | - | - | Jointing torque | 8 Nm | |
| - | - | - | Torque angle | 90° | |
| 3AZ | Oil pan on engine block Aluminum oil sump Aluminum screws/bolts are marked with blue paint. |
N54 | M8 x 92 M8 x 112 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
- |
| - | - | - | Jointing torque | 8 Nm | |
| - | - | - | Torque angle | 180° | |
| 5AZ | Oil deflector to crankcase lower section Aluminum screws/bolts are marked with blue paint. |
N54 | M6 x 20 | Replace screws Thread repairs exclusively with Al Helicoil Jointing torque and angle of rotation must be observed without fail. |
- |
| - | - | - | Jointing torque | 4 Nm | |
| - | - | - | Torque angle | 90° | |
| 5AZ | Oil drain plug | N54 | M12 x 1.5 | Replace screws | 25 Nm |