33 55 021 Replacing Both Rubber Mounts For Stabilizer Mounting
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
E61: If necessary, remove vibration damper from right retaining bracket of stabilizer.
Tightening torque 33 55 6AZ .
Release nuts (1) on both sides.
Tightening torque 33 55 3AZ .
Turn stabilizer in downwards direction.
Remove retaining bracket (2) on both sides.
Remove rubber mount (3) on both sides.
Installation:
Keep retaining bracket (2), rubber mount (3) and stabilizer if necessary clean and free from oil and grease.
Version with Dynamic Drive: Keep contact face for rubber mount on anti-friction bearing clean and free from oil and grease.