33 33 001 Replacing Left Or Right Rear Axle Carrier Compression Strut
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Driving without tension and compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- If necessary, remove rear tension strut
- Remove tank cover
- Version with Dynamic Drive: Disconnect pressure lines for oscillating motor of rear axle from tension strut.
Release screws (2).
Tightening torque 33 32 17AZ .
Release bolt (1) and remove compression strut.
Secure rear axle carrier by inserting bolt (1).
Installation:
Check threads for damage; if necessary, repair with Heli-coil thread inserts.
Tightening torque 33 33 3AZ .