33 17 005 Replacing Rubber Mount For Rear Differential Mounting At Rear

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 4 281
33 4 282
33 4 283
33 4 284
33 4 465
33 4 466

Necessary preliminary tasks:

Remove rear differential

Withdraw rubber mount with special tools 33 4 282, 33 4 281, 33 4 466, 33 4 465 and nut (1).

Fig 1: Identifying Special Tools (33 4 282, 33 4 281, 33 4 466, 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circolight (refer to BMW Parts Service).

Align rubber mount by way of elongated hole (1) to vehicle transversal direction.

Fig 2: Identifying Rubber Mount Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Push new rubber mount (1) into special tool 33 4 283.

Align rubber mount (1) by way of elongated hole to vehicle transversal direction.

Draw in rubber mount with special tools 33 4 282, 33 4 283, 33 4 284, 33 4 466, 33 4 465 and nut (2) as far as it will go.

Fig 3: Identifying Special Tools (33 4 282, 33 4 283, 33 4 284, 33 4 466 And 33 4 465)

Courtesy of BMW OF NORTH AMERICA, INC.