67 31 531 Removing and installing/replacing drive for backrest angle adjustment (front seat removed)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect plug connection (1).

NOTE: Secure drive for backrest angle adjustment (5) against falling out.

Release screws (3).

Remove drive for backrest angle adjustment (5) with fixture for plug connection (2) in direction of arrow from flange (4).

If necessary, remove inner drive shaft from drive for backrest angle adjustment (5).

Fig 1: Removing Inner Drive Shaft From Drive For Backrest Angle Adjustment

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Make sure drive shaft (1) is exactly seated.

Ensure fixture for plug connection (3) and drive for backrest angle adjustment (4) on flange (2) are correctly seated.

Fig 2: Identifying Drive Shaft, Angle Adjustment And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.