51 47 491 Removing and installing/replacing rear underbody protection
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front underbody protection .
Release screws (1).
Press heat shield to one side.
Release screws (2) and remove rear underbody protection (3).
Installation:
Center rear underbody protection (3), secure with screws (2) and then insert screws (1).