51 43 148 Removing and installing or replacing trim on left or right door pillar (top)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Lever out cap (1).

Release screw (2) and detach seatbelt strap (5).

Tightening torque 72 11 4AZ . See RESTRAINT SYSTEM - TIGHTENING TORQUES .

Fig 1: Detaching Seatbelt Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Partially loosen edge protection (1).

Unclip clips (2) of panel (3) with special tool 00 9 317 in direction of arrow.

Feed out seatbelt strap (4) and remove panel (3).

Fig 2: Uncliping Clips Of Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) of panel (2) must not be damaged.

Fig 3: Identifying Panel And Clips

Courtesy of BMW OF NORTH AMERICA, INC.