51 41 000 Removing and installing left or right front door trim panel
Special tools required:
- 00 9 317
Follow safety instructions for working on cars with airbag systems. See SERVICE PRECAUTIONS .
Side airbag is mounted on door trim panel:
Disconnect battery.
Necessary preliminary tasks:
- Remove rocker switch for side window operation . See 61 31 115 REPLACING ROCKER SWITCH FOR SIDE-WINDOW OPERATION .
- Remove footwell light . See 63 31 020 REMOVING AND INSTALLING/REPLACING FOOTWELL LIGHT .
- Remove trim on armrest . See 51 41 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT DOOR TRIM PANEL .
Press on point (A) of cover (1).
Tilt out cover (1) and release screw underneath.
Tightening torque 51 41 2AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .
Press on point (A) and tilt out cover (1).
Release screw (2) underneath.
Tightening torque 51 41 4AZ . See BODY EQUIPMENT - TIGHTENING TORQUES .
Release screws (1) on door trim panel (3).
Unclip LED for inner door compartment (2).
Unclip clips (1) for door trim panel (2) with special tool 00 9 317 .
Carefully unclip door trim panel (1) at top from retainers (2).
Version with LED for door handle/door compartment light: .
If necessary, detach plug connections (1).
Version with speaker:
Disconnect plug connections (2).
Release cable holder (3) on door trim panel (4).
Unhook Bowden cable (1) from door lock (2).
Installation:
Make sure Bowden cable (1) is correctly positioned on door trim panel (2).
Installation:
All clips (1) are white.
Fit all clips with sealing ring.
If necessary, replace faulty clips (1).
Installation:
After assembling the door trim panel proceed as follows:
- Open door window.
- Lock with vehicle key.
- Check for ease-of-movement on retaining button linkage
- If necessary, align linkages