51 21 300 Removing and installing or replacing window cavity cover strip on outside of left or right front door
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 9 324
IMPORTANT:
Observe procedure
for using special tool 00 9 324.
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).
Pull window cavity cover strip (1) out of door mirror (2) in direction of arrow.
Installation:
Coat window cavity cover strip (1) with water before fitting.
Window cavity cover strip (1) must be flush at rear to door edge.
Installation:
Seal (1) must be correctly fitted in cover strip (2).