51 16 000 Removing and installing/replacing mirror on left or right front door
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove front door trim panel
- Remove speaker (tweeter)
- Partially remove sound insulation in front door . See 51 48 060 Removing and installing/replacing sound insulation in front door, left or right .
Release cable ties (1).
Lever out clip (2) and disconnect plug connection (3).
Feed wiring harness (4) out of cable duct (5).
Installation:
If necessary, replace faulty clip (2).
Fold rubber guide (1) to one side.
Release screws (2) and feed out mirror (3) with wiring harness.
Installation:
Tightening torque 51 16 1AZ. See BODY EQUIPMENT - TIGHTENING TORQUES .
Replacement:
Due to the self-tapping screws, the tightening torque of the new mirror is increased by 2 Nm.
Tightening torque 51 16 1AZ. See BODY EQUIPMENT - TIGHTENING TORQUES .
Installation:
Sound insulation (1) on mirror (2) must not be damaged. Check function.