35 11 000 Removing and installing complete bearing block for foot pedal
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove pedal trim . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
- Vehicles with electric steering column:
- Remove electric steering column drive . See 67 64 010 REMOVING AND INSTALLING/REPLACING DRIVE UNIT FOR ELECTRIC STEERING COLUMN ADJUSTMENT .
IMPORTANT:
After completion of work, carry out function check.
Unfasten plug connection (1).
Remove locking clip (2) and disengage and pull out locking pin.
Release nuts (3) and remove bearing block.
Installation:
Replace self-locking nuts.
Tightening torque 35 11 1AZ . See PEDALS - TIGHTENING TORQUES -- 650I .