33 41 ... Detaching wheel bearing inner race from drive flange (drive flange removed)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
Special Tool Required
- 33 1 307
- 33 4 400
- 33 4 401
- 33 4 402
- 33 4 403
- 33 4 404
- 33 4 405
- 33 4 406
- 33 4 407
Position special tool 33 1 307 on drive flange. Select one of the following special tools using the wheel bearing inner race and insert into special tool 33 4 401, 33 4 405 for dia. 45 - 51 mm, 33 4 406 for dia. 50 - 55 mm, 33 4 407 for dia. 55 - 61 mm. Screw in special tool 33 4 402 until tapered attachment of spindle comes into contact with special tool 33 4 401. Position special tool 33 4 401 with corresponding insert on groove of wheel bearing inner race.
Fig 1: Positioning Special Tool 33 4 401 With Corresponding Insert On Groove Of Wheel Bearing Inner Race
Compress special tool 33 4 401 with wrenches 33 4 403 and 33 4 404 until special tool can still just be turned in groove. Detach wheel bearing inner race by turning special tool 33 4 402.