32 41 100 Removing and installing/replacing belt pulley on vane pump for power steering
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2010 BMW M6, 2010 BMW 650i, 2009 BMW M6, 2009 BMW 650i, and 2008 BMW M6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry out preliminary work as described in the document "Replacing drive belt".
Slacken screws (1)
Relieve tension on drive belt and remove from belt pulley (2).
Unscrew bolts (1) and remove belt pulley (2).
Installation:
Lettering on belt pulley (2) must point forwards.
Tightening torque 32 41 14AZ. See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .