52 16 400 Removing And Installing/Replacing Seat Cover For Left Or Right Front Seat (Sport) (M5)
Necessary preliminary tasks:
- Remove FRONT SEAT
- Remove REAR PANEL on front seat backrest
- Remove INNER COVER on front seat
- Remove SWITCH COMBINATION for seat adjustment
US/CND front passenger seat (with OC3 mat) only:
Seat cover must not be separated from padding.
All parts must be replaced completely and released with the diagnosis system in event of defective seat cover, seat heating, OC3 mat or padding.
When replacing seat cover:
If seat cover is defective, seat cover and padding with OC3 mat must be replaced together.
New seat cover is supplied with padding, OC3 mat and if necessary seat heating.
When replacing padding with OC3 mat:
If OC3 mat or padding is defective, both parts may only be replaced together.
These must be fitted with the seat cover from the car.
Up to build date 09/05:
Enabling seat occupancy detector (OC3 mat):
- Connect BMW diagnosis system
- Release seat occupancy detector
- Clear fault memory if necessary
Build date from 09/05:
Enabling seat occupancy detector (OC3 mat):
- Connect BMW programming system
- CODE airbag control unit
- Clear fault memory if necessary
Unclip cover (1) on front seat.
Release screws (1).
Installation:
Insert screws (1) with Loctite.
Place thigh support (1) on seat surface.
Release all retainers (2).
Remove all remnants of clips from seat cover and seat mechanism.
Installation:
Bend new retainers closed with pliers 52 0 050 .
Detach seat cover (1) in marked area from carrier (2) for thigh support.
Installation:
Ensure correct routing of cables.
For seat heating optional extra only:
Carefully detach felt (1) from padding.
If necessary, gently heat up stuck-on felt (1) with hot air blower.
Unfasten plug connection (2) and disconnect.
Pull cover off padding (3).
Detach seat cover (1) in marked area on left and right.
Lever out left and right clips (2).
Installation:
If necessary, replace faulty clips.
Unhook seat cover (3) in marked area.
If necessary, unlock and disconnect plug connections (1) for seat heating.
If necessary, unlock and disconnect plug connections (2) for seat occupancy detection.
Remove seat cover (3) complete with padding.
US/CND front passenger seat (with OC3 mat) only:
New seat cover must be completely installed with padding, seat heating and OC3 mat.
Release seat occupancy detector:
- Connect diagnosis system
- Release seat occupancy detector
- Clear fault memory if necessary
The operation "Replacing seat cover for front seat" ends here for the above-mentioned vehicles.
Release all retainers.
Remove seat cover from padding.
Remove all remnants of retainers from seat cover and/or padding.
Installation:
Bend new retainers closed with pliers 52 0 050 .
- Support
- Retainer
- Trim thread in support
- Trim thread in cover
- Seat cover
Replacing seat cover:
Pull trim threads (1) out of seat cover (2).
Installation:
Slide trim threads (1) into new seat cover (2). If necessary, cut mounting for trim threads.
(3) Seat heater cable