33 33 101 Replacing Two Rubber Mounts For Rear Axle Carrier (Rubber Mounts, Front)

Special tools required: 

• 33 4 140
• 33 4 142
• 33 4 147
• 33 4 149
• 33 4 431
• 33 4 432
• 33 4 433
• 33 4 434
• 33 4 435
• 33 4 436
• 33 4 437
• 33 4 441

Necessary preliminary tasks: 

• Lower rear axle carrier

If necessary, assemble special tools 33 4 140 UNIVERSAL SUPPORT , 33 4 142 and 33 4 147.

If necessary, position new thrust pieces 33 4 149 with countersunk screws on special tool 33 4 140 UNIVERSAL SUPPORT .

Fig 1: Identifying Special Tools (33 4 140), (33 4 142) & (33 4 147)

Courtesy of BMW OF NORTH AMERICA, INC.

Coat top edge of rubber mount with Circo Light (refer to BMW Parts Service).

Fit special tool 33 4 441 on rubber mount in such a way that edge of rubber mount disappears in special tool.

Oil special tool 33 4 436 slightly before use.

Align special tool 33 4 140 UNIVERSAL SUPPORT by way of openings in rubber mount.

Withdraw rubber mount from bearing bushing with special tools 33 4 436, 33 4 437, 33 4 140 UNIVERSAL SUPPORT and 33 4 431.

Fig 2: Identifying Special Tools (33 4 436), (33 4 437) & (33 4 140)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Coat new rubber mount with Circo Light (refer to BMW Parts Service).

Oil special tool 33 4 434 slightly before use.

Assemble special tools 33 4 432, 33 4 433, 33 4 435 and 33 4 434.

Align rubber mount by way of arrow to direction of travel.

Draw in rubber mount as far as it will go.

Fig 3: Identifying Special Tools (33 4 432), (33 4 433) & (33 4 435)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: 

• Bleed brakes