31 60 535 Replacing Both Gaiters on Left and Right of Output Shaft (Output Shaft Removed)

Grip output shaft (1) in vice with aluminum clamping jaws.

Fig 1: Identifying Grip Output Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing gaiter of wheel-side joint: 

Release Low Profile band clamp . See 31 60 ... Notes on Removing and Installing Low Profile Band Clamps (1) and band clamp (2).

Pull back rubber gaiter (3).

Installation: 

Feed gaiter (3) into groove of joint.

Fig 2: Identifying Low Profile Band Clamp And Band Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Press off joint (1) via contact pressure of retaining ring on shaft (2).

Installation: 

Push on joint until retaining ring can be heard to snap into place.

Fig 3: Identifying Retaining Ring On Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Lift out retaining ring (1).

Installation: 

Replace retaining ring (1).

Fig 4: Identifying Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off gaiter (1) over shaft (2).

Carefully clean all parts with a cloth.

Fig 5: Locating Gaiter And Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing gaiter of transmission-side joint: 

Release band clamps (1, 2).

Pull back rubber gaiter (3).

Detach tulip element (4).

Installation: 

Feed gaiter (3) into groove of tulip element (4).

Align band clamp (1) so that hook fastener is as at flat end of tulip element (4).

Fig 6: Identifying Band Clamps And Tulip Element

Courtesy of BMW OF NORTH AMERICA, INC.

Remove retaining ring (1).

Installation: 

Replace retaining ring (1).

Detach tripod element (2) from shaft (3).

Pull off gaiter over shaft (3).

Carefully clean all parts with a cloth.

Fig 7: Identifying Tripod Element And Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Flat side (2) of tripod element (1) must point to retaining ring.

Fig 8: Identifying Flat Side Of Tripod Element

Courtesy of BMW OF NORTH AMERICA, INC.